Turbidity Sensor

999.00

  • Working voltage: 5.00V DC
  • Working current: 40mA (MAX)
  • Response time: <500ms
  • Insulation resistance: 100MΩ (Min)
  • Analogue output: 0~4.5V;
  • Digital output: high/low-level signal (the corresponding threshold can be selected by adjusting the potentiometer)
  • Operating temperature: -20℃~90℃
Compare
Category: Tag:

Turbidity Sensor with Module, an electronic monitoring module specially developed to work with microcontroller platforms Arduino, Raspberry Pi, PIC, ARM, AVR, among others.

It is very efficient, the Arduino Turbidity Sensor is able to detect and verify the quality of the water, making the turbidity measurement, where it is possible to verify the results by means of digital or analogue signal next to the corresponding pins in the accompanying electronic module.

The Turbidity Sensor emits at its end an infrared light, imperceptible to human vision, capable of detecting particles that are suspended in water, measuring the light transmittance and the dispersion rate, which changes according to the Amount of TSS (Total Suspended Solids), increasing the turbidity of the liquid whenever levels increase.

The module pin definitions are as follows:

  • VCC: Positive supply voltage, 5V cannot be used 3.3V
  • AO: analogue signal output, output voltage range 0~5V
  • DO: digital signal output is less than the set value and outputs high level; greater than the set value and outputs low level
  • GND: negative supply voltage

Reviews

There are no reviews yet.

Be the first to review “Turbidity Sensor”

Your email address will not be published.